Written by Dr. Leo Maren · Co-founder of Fwocus · Behavioural scientist · PhD, Imperial College London
The four presets assume one method: large, fridge-cold eggs lowered into water that is already at a full boil. Start the timer when the eggs go in. When it ends, move the eggs straight into cold water. If you change any part of that method, the times change too.
I tested these times before we set the presets. Over two weekends, I cooked about three dozen eggs in my London kitchen, cut each one in half, and photographed the yolk. The presets are the times that gave the same result three times in a row. They are a starting point for your stove, not a law.
What each preset gives you
Soft, 6 minutes. The white is set. The yolk is liquid and runs when you cut it. This is the egg for toast soldiers.
Jammy, 7 minutes. The yolk edge is set, and the center is thick and glossy, like jam. This is the ramen egg.
Medium, 9 minutes. The yolk is set but still soft and slightly moist in the center. It holds its shape on a salad.
Hard, 12 minutes. The yolk is fully firm and pale yellow all the way through. This is the egg for egg salad and deviled eggs.
The white and the yolk set at different temperatures. The American Egg Board gives 62–65°C (144–149°F) for egg white protein and 65–70°C (149–158°F) for egg yolk protein.
Heat moves from the shell toward the center. So the white reaches its setting range first, and the yolk follows. A soft-boiled egg is an egg you remove in the gap between those two events. The gap is short, which is why 6 and 7 minutes look so different.
This also explains carryover cooking. The outside of the egg is much hotter than the center when you take it out. If you leave it on the counter, heat keeps moving inward and the yolk keeps setting. My first "jammy" eggs came out medium for this reason. I let them sit in the empty pot while I found a bowl. Now I put the bowl of cold water next to the stove before I press Start.
Adjust the time for your eggs
Egg size
The presets are for US large eggs. The USDA classes eggs by weight per dozen, and a dozen large eggs must weigh at least 24 ounces, or about 57 g per egg. Extra-large and jumbo eggs have more center to heat. In my tests, a jumbo egg needed about one extra minute for the same yolk. A medium egg needed about 30 seconds less.
Outside the US, size names differ. A UK "large" egg is heavier than a US "large" egg. Weigh one egg if you are not sure.
Fridge-cold or room temperature
A fridge-cold egg starts about 15–20°C colder than an egg at room temperature. It takes longer to reach the setting temperature at the center. If your eggs sat on the counter, take about 30 seconds off the soft and jammy times. For hard eggs, the difference is too small to matter.
How many eggs are in the pot
Each cold egg takes heat out of the water. Two eggs in a big pot barely change the boil. Twelve eggs in a small pot can stop it for a minute or more. Use enough water to cover the eggs by about 2–3 cm (1 inch), and keep the heat on high after they go in.
Altitude
At altitude, water boils at a lower temperature. At 2,000 feet, it boils at about 208°F instead of 212°F. At 7,500 feet, the USDA puts it at about 198°F. The water still reaches the egg-setting range, but it heats the egg more slowly. You need more time, not more heat. A higher flame only makes the water boil harder at the same temperature.
I have not cooked eggs at altitude myself, so I cannot give you a tested number. Add one minute, check one egg, and adjust from there.
Hot start or cold start
The presets use a hot start: water boils first, then the eggs go in. There are two reasons.
The first reason is accuracy. With a cold start, the time depends on your stove, your pot and the amount of water. A hot start removes most of those variables.
The second reason is peeling. J. Kenji López-Alt tested this at length, and he found that the start temperature was the factor that mattered. As he explains, eggs dropped into cold water stick to their shells, and eggs dropped into boiling water peel easily. In the same testing, he found that ice baths, salt, vinegar and old eggs made little difference to peeling.
My own results agree about peeling. I still use an ice bath, but for a different reason. It stops carryover cooking, and that is what protects a jammy yolk.
The green ring is a timing problem
A gray-green ring around a hard yolk comes from overcooking. Sulfur from the white and iron from the yolk react at the surface of the yolk and form ferrous sulfide. The University of Nebraska-Lincoln notes that the ring is unattractive but not harmful.
Two things prevent it: do not cook past the time you need, and cool the eggs fast. At 12 minutes with an immediate cold bath, I never saw a ring. At 16 minutes with the eggs left in the hot pot, I saw one every time.
A food safety note on runny yolks
Soft and jammy eggs have yolks that are not fully cooked. The FDA advises that you cook eggs until both the yolk and the white are firm to reduce the risk of Salmonella. It lists pregnant women, young children, older adults and people with weakened immune systems as groups at higher risk. For these groups, use the hard preset, or use pasteurized eggs if you want a runny yolk.
Hard-cooked eggs keep in the fridge for up to about one week. Put them in the fridge within two hours of cooking.
Timer controls
Choose a preset tab, then press Start or Space when the eggs go in. Press R to reset. At zero, a soft chime repeats for about 40 seconds, so you can hear it while you do something else. The sound follows your device volume, and some phones mute web audio in silent mode. For a sharp beep alarm, use the loud timer.
The − and + buttons, or the Down and Up arrow keys, change the time by one minute, before or during a run. For a half-minute change, pull the eggs when the display shows 0:30. Type your egg style on the task line if more than one person is cooking. The line is not saved when you reload.
FAQ
Do I start the timer when the eggs go in or when the water boils again?
Start it when the eggs go in. The presets include the time the water needs to recover, which is short if you use enough water and a few eggs at a time.
How long do I boil two eggs compared with six eggs?
The time is the same if the eggs are the same size and the water returns to a boil quickly. Cooking time depends on the size of each egg, not on the number of eggs, but a crowded pot loses more heat, so use more water for more eggs.
Why do my eggs crack in the water?
A fridge-cold shell expands quickly in boiling water, and eggs that hit the bottom of the pot can crack. Lower each egg in gently with a spoon, and lower the heat for a moment if the boil is very hard.