Written by Dr. Leo Maren · Co-founder of Fwocus · Behavioural scientist · PhD, Imperial College London
A classroom timer has a different job from a timer on your desk. Thirty people read it at once, from up to the back wall, and most of them read it while they do something else. It has to be easy to see, easy to start, and easy to ignore until the time is up.
That is the standard we used for this page. The digits sit in the middle of the screen with a large disc above them. The class sees a disc that empties, so nobody has to subtract numbers to know how much time is left.
Why the end signal is a quiet chime
The end signal only needs to be noticed. It does not need to make anyone jump.
I learned this as a teaching assistant during my PhD. I ran timed exercises on the lab projector with my laptop's default alarm. The first time it went off, it was loud enough that a student near the speaker spilled a coffee. The class laughed, and the next five minutes went to the laugh, not to the task.
So this timer plays a singing-bowl chime at zero. It starts at a moderate level and fades over a few seconds. When you press Start, it also plays one very short, soft tone, so you know the countdown is running without looking at the board.
A quiet chime has a cost. In a loud room, during group work, some students will not hear it. That is why the screen also changes: the digits turn red and pulse, and "Time's up" appears under them. Teach the class one rule for both signals: "When you hear the chime or see red, finish your sentence and look up."
If your room really needs a loud signal, use the loud timer. For a test, where any sound is a distraction, use the silent timer.
Why the presets stop at 30 minutes
The tabs give you 1, 2, 3, 5, 10, 15, 20 and 30 minutes. Most classroom timing falls in that range: a transition, a short task, a work block or a long task.
We stopped at 30 on purpose. In my own seminars, a countdown longer than about half an hour stopped being a signal. It became part of the wall, and nobody looked at it. For long blocks, I now say the end time aloud and write it on the board. Then I start a countdown for the last 5 or 10 minutes only.
You can still set a longer time. Press + or the Up arrow to add one minute at a time, up to 12 hours. At one hour and more, the digits show hours, minutes and seconds.
Run the timer from where you stand
You should not need to walk to the computer every time you start or stop the timer. Every control has a key:
Space starts the timer, pauses it and resumes it.
R resets it to the length you chose.
Up arrow and Down arrow add or remove one minute, also while the timer runs.
F turns fullscreen on and off.
A wireless keyboard on your desk or in your hand works for all of these. A presenter clicker usually sends different keys, such as Page Down, so test yours before you depend on it.
The + and − buttons change a running countdown without a restart. Use them when a group needs one more minute. A restart from the full length tells the class that the first countdown did not mean much.
What a timer changes, and what it does not
A visible timer is often sold as a behavior tool. The evidence is narrower than that.
The best-known example is the Timely Transitions Game. In a 2004 study, Campbell and Skinner worked with one sixth-grade teacher. The class timed its room-to-room transitions every day. At the end of the day, the teacher picked one transition and one target time at random. If the class beat the target, it earned a letter toward a reward, such as music during seat work. Transition times went down.
What the study shows: explicit timing, combined with public feedback and a group reward, can shorten transitions in a class. What it does not show: that a timer on the board does this alone. The timing and the reward were tested as one package. It was also one class, in a design without a reversal phase, so other changes over the same weeks could explain part of the result.
What this means in practice: a classroom timer is a measuring tool first. If transitions take too long in your room, time them for a week and show the class the numbers. The timer makes the problem visible. The routine you build around it does the rest.
Set it up before the class arrives
Open the page and choose the first preset before the lesson starts. Then press F, so the browser bar and tabs disappear from the projected image.
Check the screen from the seat farthest from the board, not from your desk. The disc is easier to read from far away than the digits. If both are too small, press Ctrl and + (Command and + on a Mac) to zoom the page. Stop one step before the timer stops fitting on the screen.
While the countdown runs, the page asks the browser to keep the screen awake. Most current browsers support this. When the timer is paused, finished or not started, your computer's normal sleep settings apply. On a projector, a long pause can end with a blank screen, so start the next countdown soon or change the sleep setting for teaching days.
An empty classroom at golden hour
The picture behind the timer is an empty classroom late in the day. Sun comes through tall windows on the left. There are plants on the windowsill, wooden desks, bookshelves, string lights and a blank green chalkboard. The disc sits in front of the chalkboard, and the digits are light, so they stay readable on the warm, shaded wood below it.
We chose a calm picture because a classroom screen stays on for a long time. It should not compete with the lesson.
The Fwocus app is not for the class. It is for the planning, marking and email that happen after the class leaves. It has more than 60 scenes in five themes, a task list and notes next to the timer, saved sessions, focus stats and streaks.
FAQ
Can I use this classroom timer on a smartboard?
Yes. Open the page in the board's browser or on the computer connected to it. Tap the tabs and the Start button directly. The fullscreen button is in the bottom-right corner, so you do not need a keyboard.
Does the timer keep going if I switch to my slides?
Yes. The countdown uses its end time, so it stays correct while another window or tab is in front. The tab title shows the time left. Some browsers slow down background tabs, so the chime can come a little late. For a class, keep the timer visible.
Can I change the chime?
Not on this page. It always plays the same soft chime. The loud timer and the silent timer are separate pages with the same controls.
Do I or my students need an account?
No. There is no sign-up and no login. The page does not ask for names, and the text on the task line stays in your browser.